Counting matching models…
Students of class 8. created a small hand shovel for our school garden, so that class 6. students can planting plants and care about their flower beds. Therefore the tip is rounded. So you can easy dig small holes or harvest radishes.
Mounting plate for the xTool F1 to laser engrave a logo on 8 pens simultaneously. Suitable for pens with a diameter of 11 mm.
Created a key cover for the XTool F1 safty USB-Stick. Now it can't get lost. Fits perfectly on my vision. Maybe you have to scale it a little bit up or down. Glue it together and everything is fine.
In education you often had to clean a lot of microscope slides after a lesson. So its good using a dishwasher for that. A holder for 30 slides make it easier. USE PETG, because the temperature in a dishwasher is higher than 60°C!
Easy Stand for Apple Pencil. Printed it in PETG with Support.
Simple Design for your Own DARC Logo. Scale it up to 300 or 400% at the Slicer.
With these four models, pupils can discover and learn the volume formula for the pyramid and the cone themselves. They are familiar with the volume formula for the cuboid and the cylinder. They measure the volume of the four solids with…
The antenna was purchased from here: https://www.wimo.com/de/hb9cv-70 . It is designed for the 70cm band and has a threaded screw mount at the bottom. The handle and stand are tailored for easy transport of the antenna. An M5 Rutex thread…
Simple Tag with a friendly Robot-Face. No Support needed. Multicolorable with MMU2s or without.
Fits poles up to 24 mm (≈ 1 inch) – the slightly tapered bore grips even thinner poles securely. Four 5 mm mounting holes for standard wood screws; mount left- or right-handed. Weather-proof when printed in PETG or ASA – perfect for…
Print the upper and down part separately. Glue them together. I used a screw to save it in the back of the Powerunit. There is a rest hole u can use. Use a flat hat screw to avoid collisions with der Extruder. No Support needed.
This add-on is designed as a practical handle extension for the Draussenfuchs Yagi Antenna Holder and allows you to securely attach your handheld radio directly to the antenna setup. With this handle, the radio can be plugged into the…
The HamClock project is an open-source tool for amateur radio enthusiasts. Link: HamClock I designed a case for a desktop version based on the Waveshare 7" touch display and a Raspberry Pi 4b. I used M2.5 heat-set inserts and standoff…
This two-part, 3D-printed slip-case hugs a single volume (Vol 1 or Vol 2) like a classic hard-cover, protecting those gorgeous copper traces while adding a splash of colour to your workbench. Perfect fit for one Reference Circuits volume…
These are all currently available results.
