Counting matching models…
base.stl and top.stl printed 10% infill top.stl print it with the letters down to the bed no supports needed for the base.stl supports only in the middle the other overhang sections dont need support use support blockers as in picture…
UPDATE Jan 26th, 2025 Added an updated vesion fo the stand Switch Pro Controller stand- zelda remix_v2.stl removed the hole made by the trifoce emblem hole so now you can put the glue in to paste the trifoce emblem UPDATE Jun 5th, 2023:…
print it laying in one of its sides
Rafts: No Supports: No Resolution: 0.2 Infill: 10% Notes: The logo and the letters may require a raft or brim during printing, and some glue for assembly.
modified the nebula model to get the space to attach the cr touch and the g sensor at the top
Removed the slots for micro sd, it has instead 2 more slots for the sd adapters
Print and use some double tape to paste into alexa side Fuse needs some sanding at the bottom in order to fit the neck Neck should be printed upside down, that is the sphere cut facing up
I was searching for a screwless filament feeder but that was a twopiece so it could fit into my cctree drybox as the hole is as in the image below I combined this two models https://www.thingiverse.com/thing:1750875 +…
This is a Satsana duct remix to fit the crtouch holder that also has the vibración sensor from the nebula pad without the need to set a x or y offset as the cr touch stays as in the original place Same settings as the original this was…
hold two solder paste with a diameter of 56mm
stores the AC plugs adaptors from 3 pin to 2 pin using gridfinity
I printed this low poly mew https://www.printables.com/model/8640-low-poly-mew and pasted above this base to make it like a lamp and to put the battery (the circle ones the watches use), switch and led inside The hole in the middle of the…
UPDATE 21/Jan/2024: Added button_v5.stl as the original button was badly designed and frail, please print this new version in the following settings for better results: Resolution 0.12 infill 100% brim enable (optional) no supports needed…
Remixed from this original model, you can find the other parts over there: https://www.thingiverse.com/thing:4013034 Printer brand: Creality Printer: Ender 3 Rafts: Doesn't Matter Supports: Doesn't Matter Resolution: 0.2 Infill: 25%…
These are all currently available results.
