Counting matching models…
This tray replaces the owl that is provided with the CR Scan Otter and allows for storage of up to 12 magnetic markers. I modified the marker pyramids to use magnets with a diameter of 6mm and a thickness of 5mm. But the original pyramids…
I remixed the Dremel Holder to hold the Dremel 8240. It can either be used with, or without the battery. However, if you leave the battery in the Dremel, it will stick out ~5mm and might interfere with the part next to it.
To make filament loading easier and reduce the drag on the filament I designed this PTFE guide. It is designed for the original reverse bowden tube which has an outer diameter of ~4.4mm (instead of the normal 4mm). I would not recommend…
I designed this 3D printed plate to turn a lazy susan into a low profile scanning turntable, which easily fits in the hardcase of the Creality CR Scan Otter. The white dots are not detected as reflective markers! However they are being…
This is a simple filament feed-through for the Snapmaker J1, if you want to put the spools inside the printer. There are version which go straigt up and versions that are tilted 20 degree to the left and right. You don't need any tools or…
Simple Spool Holder to install the spools inside the printer. This makes them more easily accessible, saves space behind the printer and allows you to immediately see which filament is loaded. I decided to make use of the two individual…
This case allows you to use your Raspberry Pi 5 together with the Geekworm X1001 NVMe SSD hat and the Waveshare rear IO adapter with full size HDMI ports. Most of the parts should be interchangeable to the model by JoKneeMo. Just some…
To be fair, this fan shroud barely improves the partcooling. On some prints there was a slight improvement, on other prints it was exactly the same result. I think with a more powerful partcooling fan like the GDSTime 12000 RPM Fan it…
I designed an adapter to use a longer and more flexible cable for the CR-Scan Otter. This model is specific for this 3m long angled cable I found Amazon in Germany: Cabletex USB-C Cable . While I found two models on amazon.com that look…
I saw a similar bowden coupler and really liked the idea. So I made my own version which works with both, the standard PC4-01 M10 bowden couplers for 4mm bowden tubes or with the original 4.4mm reverse bowden tubes of the Snapmaker J1.…
This camera mount only works when you either remove the lid or raise the lid by at least 15mm. Maybe you could also design a similar mount which sits a bit lower, but I assume the camera might collide with the ribbon cable. I designed a…
This air filter with activated carbon pellets helps to reduce the fumes/smells from printing ABS or ASA by recirculating the air inside the printer. This also helps to create a more even temperature throughout the build chamber. Make sure…
Previously I had a Sunlu S1 Drybox mounted to the rear of my J1, but recently I upgraded to the Snapmaker SnapDryer (aka Polymaker Polydryer ) and were able to fit both the dryer itself with two storage boxes to the rear of the machine.…
All you need for this modification is this small USB-C board and a 5 Pin JST SH 1.0 connector . The old wired Spacemouse Compact uses the same 5 Pin connector for USB. But due to the metal housing it is more difficult to modify it with…
These are all currently available results.
