Counting matching models…
I printed in PLA 0.3 draft layer height with brims. I had to clean up magnet holes a bit before magnets fit snugly in. There was a bit of a gap between front and back so I used a soldering iron to further sink the magnets in place. One…
Prints in 3 pieces. A bit of a struggle to get all pieces to fit together with the wireless charger and cables as the centering/aligning and the angle of the cable connector don't align. Printed with support cubic at 5% for body and 10%…
Print was very finicky for me. Print one part at a time and use brims. I did not use supports. For the board, I used the slice feature in PrusaSlicer so that it has a flat base.
These are all currently available results.
