Counting matching models…
The DDCS V4.1 comes with four holes in side to mount it into the panel. I just needed a box to hang off the side of my mill while putting the rest of electronics under the mill. There is a drawing provided if you need to modify it. Parts…
This holder just prevents run away disc going throughout your tool box. It has two holes in bottom of print that can hold ¼ x ¼ in magnets. Can get magnets from Kj Magnetics part number D44.
This is to replace the Seadoo part number 204050803 that cracked and crumbled. I went with PETG. First flat standard one. The other i made deeper so i could zip tie a charger cable in there and hide it when the back lid of boat is shut.…
Print 100% fill. Holes in back plate is where you can push .25 x .25 inch magnets to old it metal surfaces. One of the models has a hole where you can use a screw threw it. I'm using them to hold test leads, cables or even head phones.
Other models of these found didn’t have a good alignment to bolt holes within boat.
ICON 3/8 in. Drive Metric Professional Shallow Socket Set, 12-Piece Holder
ICON 3/8 in. Drive Metric Professional Semi-Deep Socket, 12-Piece. Let me know if you have a full-length sets and fits it also. Thanks
PITTSBURGH 3/8 in. Drive Metric Impact Swivel Socket Set, 7-Piece Holder. Holes in back can fit 1/4x 1/4 round magnets to help hold it.
Bench top hose adapter going to 2.25 ID hose. This adapter has slight tapers on inside. I'm sure you can buy it but then what would my printer have to do?
These are all currently available results.
