Counting matching models…
The amount of additional space required just because of the original prusa heatbed cover is just insane. By creating this low profile 90 degree angled heatbed connection (and some other space savings) I even managed to get my printer into…
Make sure your printer is well calibrated and be a little gentle when pressing in the amazefit core for the first time. Needs a 22mm elastic band. You can pick either of the buckles. Printed in PETG with supports for the rounded overhangs.
I wanted a Dremel mount that - can be clamped to a table or into a vise - does not require me to rotate the dremel/holder to screw it in - should be easy to print I didn't really find a model that ticked all the boxes. Printing should…
The Sonoff Pow R2 is great. Especially with the Tasmota firmware. I just fail to understand who came up with the stupid design of the original enclosure. Leave the outer insulation out? No strain relief? Instead of printing a whole new…
I needed a prytool to open a housing without scratching it. I didn't find any good model so I created this one. I suggest to increase walls to 3-4. Filaments like PETG/PLA/ABS should be fine.
Instead of a 18650, connect your PSU to the two contacts. Not fully round for an easy print. Needs two M4 screws and nuts. Best to use copper or at least brass screws.
Holder to mount Ikea Räcka as a cloth rod in e.g. the Stuva cabinets. For more strength print on the side with support. If you don't need that much strength printing flat without support is good enough. I printed this in PLA. Top Layers:…
I didn't have a male molex header but the standard 2.54 pin headers work fine as a male part. With this housing you can print your own male molex adapters.
I needed to mount a smaller platform on a stand. A lighting stand with 3/8" to 1/4" top worked fine. Easy print.
These are all currently available results.
