Counting matching models…
I upgraded my Creality K1 Max to a Manta M5P ( check out my M5P mount here ) and switched the screen to a BTT HDMI 5. I created this mount because there wasn't any out there. The .3mf has OrcaSlicer settings for a K1 Max. Features No heat…
Simply put this is a mount for the BTT Smart Filament Sensor (SFS) v2.0 to the K1 Max that allows for feeding from the side. I'll update the model as I receive feedback. I haven't tested this on the K1/K1C, but it might fit. I have also…
Updates to V2.1 Changed the mounting holes for the microprobe from 2.8 to 3mm. Opened the X axis of the hole for the probe by 0.2mm to make it easier to insert the probe. This is an update to my previous v1.0 model. Since there wasn't a…
NOTE: This is meant for the K1 Max. If you are upgrading a K1/K1C use the other mount from Bootycalljones (linked below) Are you tired of running out of RAM? is your printer hanging up, or even worse, crashing? Maybe you'd like to upgrade…
Simply print off either the 23.5, 25, or 25.4mm OD model for your size of conduit, insert 2 ea. M5x30mm screws and 2 ea M5 nylock nuts(from the BOM), then your Z-rail flush with the “flush end” printed on the jig, then use the 2 holes to…
This is my remix of the back cable channel only. Since this is v0.1, I'll update this page as I make any needed changes. Print settings: 0.5 line width 0.25 layer height 10 walls 5 top 5 bottom
This is my test version (v0.4) of the mount for the Orbiter 2.0 on “The 100 v1.1”. I needed a better extruder than the BMG clone, so I'm using this to mount my Orbiter. This mounts in the same place as the original BOM extruder. I'll edit…
I remixed Bart Dring's RJ12 case for the Fluid Dial Pendant which uses and connects to Fluidnc controllers using this RJ12 kit . I added grippy textures to improve handling and aesthetics. I have included the .step files for you to…
Please refer to the google doc for installation instructions. https://docs.google.com/document/d/1aC8nJHKZ60ijaI1a4g7mm5B1aGo4swkHeUrHh0CYlwI/edit?usp=sharing I encourage non-commercial remixes of my models so I have posted the STEPs. You…
THIS IS AN OLD VERSION My V2.0 mount is published here: https://www.printables.com/model/701963-btt-microprobe-mount-for-the-100-v11-printer-v20 This is v1.0 of my mount for the new BIQU (Big Tree Tech / BTT) Microprobe on "The 100 v1.1"…
These are all currently available results.
