Counting matching models…
I redesigned from scratch my favourite silica container by Malolo. I loved absolutely everything about it, except that it prints a little slow. I used horizontal slots so that it prints much faster with less retractions and hops. In 0,3mm…
This is a crate-style stackable tray. I needed some boxes to shuffle 3D print waste around my place, but I ended up stacking some and storing stuff with it. I exported the f3d archive with parameters if you want to change the dimensions a…
Fits M10x0.75 fittings. Hardware required is 4xM3 socket head bolts and matching hex nuts. Added a STL for a TPU/TPE seal if the surface isn't even but I haven't used it.
This funnel has an outer lip and uses 16 magnets (4mm diameter, 2mm height) to hold onto the portafilter basket. It prints upside down without supports. Should fit most 58mm baskets. The bottom lip has a 70.2mm clearance, with a 58mm…
Non permanent webcam/privacy cover made to hang on a Dell XPS laptop lid, for those who cannot physically modify their (work) laptop or don't want to damage the screen when closing the lid. It should dramatically fly off if you swing the…
A single pill… every day… at the same time. You'd think it wouldn't be so hard to remember if I've taken it, right? Right… So here it is; a thing that does it for me. This pill bottle replacement contains about a month's worth of pills…
This is useful if you have an office chair with casters and you want it to stop rolling around for some use or other, and also don't want to swap the casters only temporarily. You can stand a few of the casters on the blocks so that it…
No hardware required to assemble other than 2x 608 bearings (the ones that come with the MMU). I use them at the bottom of a Rubbermaid 21 cups drybox. Versions v1.1: recessed nuts w/ proper bridging, added hexes, cause they're all the…
Funnel with a simple paddle to stop the flow of, say, rambunctious peppercorns fleeing the pepper mill all over your kitchen floor. Not that it ever happened to me...
Your printer needs some Christmas cheer! You can split the STL to parts to select an extruder for each section of the boot and accent lines. The buckle part is raised. I wish I had made the cuff raised as well. Be careful that your…
The provided IKEA clamp jaw for the TERTIAL lamp base is flat and is not compatible with the BROR workbench because of the thin steel construction so I made a deeper jaw for a friendly reach around. It's not like I'm going to use real…
This is my design for an angled wireless charger using the round IKEA Nordmärke for electronics. It is essentially just a stand with a hole in it. It has minimal cable management at the back. The phone mount was designed for an iPhone X,…
These are all currently available results.
