9 models
Allows headphones or a headset to be mounted anywhere on either top side of the Corsair 5000D Airflow case. No mounting hardware required - kept in place by the removable top vent cover. Just pop up one side of the vent cover to put in…
If you find my designs useful, please consider sending a tip I recently mounted my GeForce RTX 3080 vertically in my Corsair iCUE 4000X case using the Linkup PCI-E 4.0 Riser Support cable but I was concerned about how much the Riser's PCB…
I created a perfect fit Airduct for my 5000D case to help get more dedicated air to my GPU. Printed with 0.2mm / PETG / Printed with the studs on the bottom + support. I've used a 120mm Noctua AF-12 fan, every other fan should work too as…
My LED strip running underneath this gap and would shine in my face from certain angles, this plate should press-fit to block the ugly gap, incompatible if you have a front-mounted radiator (hopefully that would be fairly obvious). I have…
very easy to print supports not needed infill 20%
Top Fan Shroud for Corsair 5000D RS This Top Fan Shroud is custom-designed for the Corsair 5000D RS case. It’s made to hide fan cables, RGB wires, and connectors at the top of the case — while also providing a clean mounting area for an…
Funnel for not expensive anemometer HoldPeak HP-5000D. It can be used to measure air speed/volume on up to 200mm diameter pipes. I've used it to check my HVAC (recuperation) at house. There are other funnels, sadly each of them (also this…
GPU support for EVGA RTX3080 FTW in a Corsair 5000D Airflow case, 4cm lift and magnet holes to secure it to the top of the power supply enclosure, also made it so you can print without supports. It uses x2 6x3mm magnets. I have an ARORUS…
Au lieu d'un support en nid d'abeille. Il y a plusieurs triangles pour se fixer sur la grille des boitiers Corsair 4000D Airflow et Corsair 5000D Airflow. Le support rentre pile poil dans la grille, aucun jeu.
