Jabra Speaker 60deg Stand
A handy stand to set your Jabra speaker at 60deg on your desk. Improves sound directionality.
- Downloads
- 384
- Likes
- 47
- Rating
- 4.57
14 models
A handy stand to set your Jabra speaker at 60deg on your desk. Improves sound directionality.
This fully 3D printable laptop stand is ideal for 13-14 inch laptops. Has max angle of tilt of 60 degrees. Need to use 2x Paper pins (<1mm diameter) to fasten the hinges. I have included the STEP files so customization is feasible for…
IMPORTANT: You need to add this to Line 20 of the G-code: M302 S85 This allows the Printer to do the Cold Pull. Be aware, that this is normally deactivated due to Security, since a Cold pull is pretty hard on the Printer, and should only…
Designed specifically in cases where your cable connections to your MK52 heated bed is tall - in my case due to a combination of using a slightly thicker cable and using ring terminals with a really thick insulation layer. This cover is…
This bracket brings two 2020 extrusions together at 60 degrees and has a clamp for a 16mm wire shelf post. I designed this for building some triangular printer stands, but I figured I'd share them on their own in case anyone might have a…
EZVIZ bullet camera and solar panel mount at 60 degrees angle. (If need to have it to the other side: mirror the model in slicer). Model was designed to be mounted to baseboard/fence with 8pcs of 4x20 wood screws. Camera base mounted with…
Type of corner / connector allowing to build a number of bespoke gates for Whoop Drone Racing. Fits 20mm or 22mm PCV Other Drone Accessories here: https://www.printables.com/@StudioMechanik/collections/3053772
Type of corner / connector allowing to build a number of bespoke gates for Whoop Drone Racing. Fits 20mm or 22mm PCV Other Drone Accessories here: https://www.printables.com/@StudioMechanik/collections/3053772
nonfoldable testversion for my fg-24 Category: Props
Use to mount LEDs or other accessories
as of the insekt net wide i needed a DN16 60degree but nowhere to buy and the 45deg is so tiny and breks so i decided to go for a 3mm wall print so it is DN16W60 3mm prints in 20 min fits perfect holds like hell and it is what i needed…
While setting up my enclosure, I wanted an easy way to use the same spool holder upside-down, as well as upright. I found the Filler Filament Holder and designed a rotating adapter, all while being able to keep using the Filler prints…
Type of corner / connector allowing to build a number of bespoke gates for Whoop Drone Racing. Fits 20mm or 22mm PCV Other Drone Accessories here: https://www.printables.com/@StudioMechanik/collections/3053772
Type of corner / connector allowing to build a number of bespoke gates for Whoop Drone Racing. Fits 20mm or 22mm PCV Other Drone Accessories here: https://www.printables.com/@StudioMechanik/collections/3053772