9 models
Two easy-to-print hooks for adding an additional drive - WD Passport - to your Synology DS218 server. Add adhesive felt pads and everything will sit tight.
Print approx. €0.97–€1.18 excl. taxPreliminary estimate for one variant
Ein Unterbau für das NAS DS218+. Seine Innenabmessungen betragen 85 mm x 187 mm x 25 mm (B x L x H). Die vier Füße des NAS passen genau hinein. An der Vorderseite befinden sich Schlitze zur Luftzirkulation, an der Unterseite vier…
Print approx. €2.03–€2.48 excl. taxPreliminary estimate for PETGSource material: PET
This is a small SSD mounting adapter for my Synology DS218+. Theoretically this should also work for other "slot"-type drive cages. Note that the latch is missing the little pin on the front. Original source for the adapter plate:…
Vibration dampening support to be placed under the NAS's square foot. May fit any model that uses the same 13 mm side foot. To be printed in TPU - for my usage, with only one “heavy” 3.5" hdd installed printing it with two walls, 0.2 mm…
A Simple Holder for DS218 and DS218+, DS220+, and DS214Play. DS216+II Print Settings Printer: A30 Rafts: No Supports: No Resolution: 0,22mm Infill: 25% Filament: Janbex PLA RED Post-Printing Mount it to the Wall I recomend to use Screws…
Synology DS218+ Dust cover 群晖DS218+防尘罩
This is a Synology DS218/DS220/DS224+ Stand to reduce noise and vibration. It also helps with better ventilation. You need door seal stripes at the bottom of the stand with a 9mm width. I used these:…
My first model, simple and overkill, but effective. Takes about 1.5 hours to print, print two for both ends. Print in TPU without supports, with the following parameters: Material: CR-PLA_1.75 Layer Height: 0.15mm Wall Line Count: 3 Top…
Synology DS218play 3U 19-Inch Rack Mount This rack mount installs a Synology DS218play horizontally in a standard 19-inch rack while using only 3U of rack space. The NAS is held by an open four-part cage consisting of front upper/lower…
