PitStop FanCover
To cover the colorful Noctua Fan or the PitStop-Extruder and bring it back into the color concept.
- Downloads
- 17
- Likes
- 2
- Rating
- 0
16 models
To cover the colorful Noctua Fan or the PitStop-Extruder and bring it back into the color concept.
Screwless Snap Assembly. Start with base or bottom case, remove ssd and drop Pi4b board into bottom case so that it rests in provided IO openings correctly. Fit should keep board in place even with a little shake. Place…
I remixed the fanconnector as it was too small for my WinSinn 5015 fan and my part cracked upon insertion of the fan.
J'ai réalisé une protection du ventilateur pour la Tina2, en m'inspirant de celui de la Tina2S. Print Settings Printer brand: Zortrax Printer: M300Plus Rafts: Yes Supports: No Resolution: 0.2 mm Infill: 100% Filament brand: Zortrax…
Regulační knoflík k fancoilu / Control knob for the fan coil
The fan has an elevation on the outside so i could not decently fit it in. With the gap i can force it in a little bit. I also changed the screw holes diameter from 2,5 mm to 2,7 mm because my connector almost broke when i screwed in the…
I was looking for some fan cover for my pc. And i hella love vaporeon and didnt find any Fancovers with vaporeon theme. So i decided to make my own. The two pieces should fit with slight wobble so i (about 0,50mm tolerance) so i just…
This is a replacement for the brackets that I may or may not have lost at some point. I've verified this to work with the kit ( HD20Ext-Aud ), receiver ( HD20Ext-RX ), and cascade ( HD20Ext-Cas ) models. It may fit others but these are…
Fancover 30x30x10 Category: 3D Printing
Introducing the Fancon (fantasy console)! This is a raspberry pi powered TV console for playing fantasy console games off of floppies. Currently, this project supports TIC-80 and PICO 8. This project requires zero soldering. How this…
I printed the Butterfly printhead fro my AC Vyper which was created by "DerLatzer" on Thingiverse https://www.thingiverse.com/thing:4974423 which worked pretty good for me, as long as I was using the factory VolcanoV5 Hotend. After…
Holder for a 140mm Fan for my Simrig, i can also make a 120mm version if its needed for someone.
This is a cover for a 40x10mm fan. I wanted to cover the fan somehow after modifying the cooling in the Ender3v3SE. The design comes in four variants and is printed in PLA. If you like the design, consider leaving a tip ;) Jest to cover…
I was looking for some fan cover for my pc. And i hella love vaporeon and didnt find any Fancovers with vaporeon theme. So i decided to make my own. The two pieces should fit with slight wobble so i (about 0,50mm tolerance) so i just…
J'ai réalisé une protection du ventilateur pour la Tina2, en m'inspirant de celui de la Tina2S. Print Settings Printer brand: Zortrax Printer: M300Plus Rafts: Yes Supports: No Resolution: 0.2 mm Infill: 100% Filament brand: Zortrax…