7 models
This allows redirection of filament for easier travel to hot end when printing with a top mounted spool holder. Installation and Design explanation: Runout Senor Bracket: Tighten down the bolt to sensor bracket to the bottom base. Then…
Filled some of the output sections. If you plan to have your Ecotech MP40 near the bottom of the aquarium and you're worried about blowing away the sand, maybe this merged guard+redirector project can help. Haven't yet tested how useful…
I have an air vent that is pointing directly at my 3D printer. The cold air shock was causing some warping on larger prints. This allows me to keep the air blowing in the room, just pushing it to the other side which appears to be…
I printed these to screw them onto the outlet of the air filter. They are at a relatively exact 90° to the back of the fan. I believe they were attached by drilling through and screwing them onto the grille. The corresponding counterpart…
Little chute to redirect output air from DW660 to blow onto the cutting area. Two little pegs are intended to fit within the output ports to hold it in place. Two holes near the top of the part are intended for #6 sheet metal screws to…
Custom 3D printable holder designed to replace the original central ventilation grille in the dashboard of a Škoda Felicia . It allows you to integrate a 7-inch touchscreen (Raspberry Pi display) into the center console while maintaining…
This is a clip on mod for the 8bitdo Pro 3 - taking inspiration from some the levered Xbox controller accessibility mods to effectively redirect the extra buttons on the shoulders to be inline back buttons. You assemble it with the left…
