DRV8825 Stepper Motor Driver Module with Heat Sink
See https://www.amazon.com/gp/product/B075XH1TSJ/ref=ppx_yo_dt_b_search_asin_image
- Downloads
- 119
- Likes
- 9
- Rating
- 0
12 models
See https://www.amazon.com/gp/product/B075XH1TSJ/ref=ppx_yo_dt_b_search_asin_image
This will replace the plastic wheel for the RV-8 60E. The wheel is a split design that pushes together. Pull the old/damaged wheel apart, then press these 2 halves together in the foam wheel. I printed this with supports. When assembled,…
The Cooling solution is based on Driverboards for DRV8825/A4988 and a centrifugal blower Blower https://de.aliexpress.com/item/32832503095.html Stepper Driver connection Board https://de.aliexpress.com/item/32848685464.html Everything…
Wing bolt extensions to make it easier to install and remove wings on the RV8-60E Total weight - 8g each Materials needed" 2 - M4 screws Instructions: Print the extensions using a brim for bed adhesion. When the print is complete, insert…
This model is designed to make the missing steps issues on drv8825 stepper drivers more observable. If you're noticing weird artifacts on your print and your printer is using drv8825 stepper drivers, chances are your printer is affected…
Flex Innovations RV-8 60E Float Mounts - The mounts are to strengthen, and make reliable, the mount locations on the floats for Flex Innovations RV-8 60E, and Cessna 170 60E Problem: The wood mount locations get infiltrated with water,…
Wing tube handle for picking up and maneuvering the plane. You install it by placing the handle in the fuselage, in line with the wing tube holes and then insert the wing tube to hold it in place. With this handle in place you can easily…
Yes, mini drone motors and DRV8833 motor driver could be superglued together without any help. But that would be always slightly different robot bases. The 3Dprinted part gives motors and motor driver a defined position to superglue to.…
I wanted a printable bracket for my Flex Innovations RV8 10E because the provided molded plastic bracket was badly warp and would not sit flat the main landing gear mount. Designed in Fusion 360 (as best I could) and printed in PLA, with…
These mounts allow you to mount the CESSNA 170 60E G1/G2 Floats, and struts, to the RV-8.
A tray to hold the Raspberry Pi 4 in an aluminium heatsink case next to the Adafruit DRV8847 motor driver breakout. The settings don't really matter, but you can print this with organic supports on the buildplate only on the large flat…