The source marked this model as adult content.
- Downloads
- 254
- Likes
- 44
- Rating
- 0
6 models
⚙ RECOMMENDED 3D PRINT SETTINGS Material: PLA or PLA+ recommended Layer Height: 0.16 mm for finer detail; 0.20 mm for faster prints Infill: 10–15% recommended for most models Wall Loops: 2–3 Supports: Enable where necessary based on model…
Housing for a 120mm fan for sucking or blowing air. This version does not have a filter (to increase its air flow) Just use four M4 countersunk screws. You can additonally drill (or "solder") a hole for a switch. Have fun!
A Teflon tube with an outer diameter of 4MM and an inner diameter of 2MM is inserted into the mouth.
So I got myself the Gardena 4700/2 pump (model 9025-29) and threw it straight into my rain barrel like a responsible adult. Only problem? It was sucking up more mud than water , like it was trying to drain a swamp instead of irrigate…
You will need these thinks: Power cord for 230V Rubber band 4x Fan 120x120x38mm Air vent hose from NEDIS diameter 100mm Screw 4x Clip for 2 wires Printed Main body, Lit and 2 ends Both air vent hoses does not need to have same size. I am…