Counting matching models…
I got one Switch TP-LINK LS105G and to put under the table I checked different options but none fits my needs, so I designed this one that need two screws and hold it nicely under the table without limit the airflow for cooling. Printed…
Introduction When I decided to assemble my HomeLab Rack I wanted each device to have its own dedicated holder, as I like to keep everything tidy and wanted to avoid a mass of shelves. Unfortunately I couldn't find any satisfactory…
Hey everyone, i designed this ring for the Feiyutech AK2000S but it should fit other follow focus gear as well. It has been specifically been designed for a print in TPU to slide the ring without damage over the Sony SEL 18105G lens. Be…
Mercusys MS105G desktop switch holder, made it as my one was always on floor. No supports
The simple cover for TP-LINK to mount on the wall.
desk mount to be used under or on the desk, however you attend to use it.
Wall mount for the D-Link DGS-105GL 5-port Gigabit switch. Ideal for tidy network setups.
Simple wall mount for Mercusys MS105G
Holder for two tp-link LS-105G 5-port gigabit switches that fits into 1U of 10 inch rack space. Uses the rubber feet on the bottom of the switches to secure them in place. Print orientation: front face down on the bed ( = no supports…
Tested with PETG, 0.20mm "strength" profile; 6 walls, 15% infill, tree supports, mouse ear brim.
Pour fixer ce mini switch sous le bureau
This is a vertical stand for the Mercusys MS105G network switch. One of the models has a 45mm wide base for a smaller footprint, and works better if attached to the surface using double sided foam tape. The other has a 60mm wide base and…
this is a remix from CHARL13's model. Brackets for mounting a Netgear GS105 switch to the Multiboard mounting system. You will need to print 4xHandsOnKatie_Standard-Underware-Connector from the original remix file library.
I have yet to print this one myself. It is meant to be printed upright with no support, but the ventilation overhangs may be a little bit too steep. Supports may be needed. A couple of 2mm holes are located on the bottom to lock in the…
Edit: Added v6 vesion - cutouts has keystone dimensions (15x 19.5mm) Just simple 10 inch rack mount for Mercusys MS105G switch. I used two M3x8 bolts and nuts to fasten switch to baseplate but I left two bigger holes just in case (maybe…
Clean up your desk setup the simple way. This under-desk mount is designed specifically for the D-Link DGS-105GL , allowing you to securely mount the switch beneath your desk for a clean, clutter-free workspace. No supports needed.…
This is a vertical stand for the Mercusys MS105G network switch. One of the models has a 45mm wide base for a smaller footprint, and works better if attached to the surface using double sided foam tape. The other has a 60mm wide base and…
