Counting matching models…
FDM -> It is recommended to use a layer height below 0.15 for printing. It is recommended to use LCD or SLA for printing to obtain higher precision. "A series of high-precision bullet models." In order to meet the needs of military…
Resized Fire Extinguisher or Gas Torch Holder by The_BeardBot to fit my larger 108mm diameter extinguisher. The screw holes sizes are in tact so the same hardware can be used. I just used some doubled up electrical tape for the strap.…
Simple Hex Storage Crate / Utensil Holder A lightweight storage crate featuring integrated finger holes for easy handling. I designed this with a hexagonal pattern on the walls to reduce material usage. Please Note: I haven't had the time…
A 4.25" or 108mm vent for RV exteriors. Category: Outdoor & Garden
A simple BRIO-compatible level crossing designed to drop straight into your wooden railway setup. I’m using my usual approach with female-only connectors and a separate insert to ensure a snug fit across different brands. Prints fast, no…
Designed for the Spyder Tarantula Hole saw but should work on most any brand 4-1/4" (108mm) I have made it short for that reason and to save on filament. I used .15mm Speed @ 20% infill I used no supports and you can see in 1 picture were…
Model of the 12.7x108mm DShK cartridge with bullet and casing in seperate files so you can print them in differnet colors. 1:1 scale within 0.01mm (sorry no freedom units here). Use superglue to conect the parts. Casing is made to be…
I wanted somewhere to neatly store some deck boxes I did a remix of so I created these. Super basic, tolerance was decently snug for my a5m. The ‘embossed’ slides are a bit shorter so that they can be pushed all the way to the back of the…
I designed this adapter mount to make it simple to install the ReoLink outdoor POE security camera in the location of my older security cameras. The older cameras had a 108mm base, but the new ReoLink RLC-843A have a 128mm base mount.…
I made this simple frame to fit a large size Polaroid instant photo (89x108mm). The slot in the back is cut out to allow for easier removal of the photo without touching the front. I printed it at 0.2mm layer height which took around 4.5h…
Made this model to properly close the housings of my filtering setup. Made the handle wide enough to avoid weak spots that can lead to failure. Used 50% infill and 5 perimeters so it's pretty strong.
