Counting matching models…
I tried all available clip designs and found that flyin_kapet's “Notch” version worked best. These are a simple revision of his design that doubles and triples the capacity. You do need to push the pellets into the center of the clip with…
Baseplate adapter to make 10rd p365 magazines compatible with the macro grip. Mainly designed for compliance in 10rd limited states. Can be printed standing up, or on its side. Recommended 4+ walls.
Replaces the standard magazine insert in the Magpul GL9 mags for a Glock 19. Reduces the magazine from 15 down to 10 rounds for communist states like California, New Jersey, New York, etc. The floor plate must be epoxied on so that you…
I wanted a small, sturdy package to take along a few rounds to the range, so I came up with this minimalist design. The case rests on its shoulder, so the bullet of a standard FMJ round has no contact with the box. The lid has a few ribs…
allow standard 10rd magazines to be used in xmacro grip module
This modified follower allows for 10 rounds of 22LR to fit in the standard 8 round magazine of the Beretta Bobcat 20x. To install: Remove the pin from the existing follower. The pin has a pointed end. You must push the pin out from the…
Reduces the stock 15 round magazine down to 10 rounds for communist states California, New Jersey, New York, etc. You must epoxy the base plate on so that this limiter can't be removed for this to be legal in commie states. For the Smith…
This is a block to go in the 20 rd M1 Carbine magazine to limit it to ten rounds. This can then be pinned in the mag if needed using a a drill and a pop rivet. If you need to adjust how many rounds for hunting restrictions just scale up…
Just sliced off some of the middle section from the original file to shrink down the size, enjoy!
Magazine limiter for Browning Hi Power to reduce its capacity from 15 rounds to 10 rounds. I've printed it in ASA, however any material should work. In terms of supports - if printed 2 parts separately, no supports are required, however…
This is a flush fitting p365 baseplate to utilize 10rd magazine body fitted to XL frames.
I wanted a chunky sleeve for my straight talon magazines that contributed a little more to the theme of the Ontos. These are definitely chunky, but the heft allowed me to add a little curve to them which is cool, and on a 10rd mag it…
Love the original mag bumper by Oorbit Designs, I think it really completes the blaster. I wanted a version without the diagonal lines though, and since it was a bit plain without them I thought a little grip notch and some optional…
This is a magazine base for S&W 10rd magazines to make them fit compact grips flush. I didn't like the 2 piece extenders that came with my S&W FPC so I designed this. (Final model is a little different from the white prototypes pictured)…
