11 models
This cable holder replaces the BMW OEM clip 33 18 1 181 218 (33181181218). It routes and secures wiring on the suspension—typically the brake pad wear sensor at the rear, and in some models also ABS/signal wires—so cables don’t chafe or…
The Bosch RA1181 router table does not come with a miter gauge so this solves that problem. This design includes 2 sliders: one with a detent for 15 degree increments, and one with out a detent to allow for any angle to be set. The main…
My OEM fences would swell up from the year-round humidity, so instead of buying replacements, I designed these. Print Settings Printer Brand: Ultimaker Printer: S5 Rafts: No Supports: No Resolution: 0.15 Infill: Any Filament: Any Any Any…
I mounted the Bosch RA1181 router table on my table saw and mounted a Triton router to it. I wanted a simple place to put the accessories (extra router plate inserts, spanner, lift arm, extra collet) and cord management so that they're…
Table holder for Denon remote RC-1181 Print Settings Printer: Anycubic i3 Mega Rafts: Doesn't Matter Supports: No Resolution: 0,2 Infill: 20% Category: Audio
Print with no support. Add small rubber knob under for stability.
On my Bosch RA1181 router table, the inset rings (red hole caps) are not flush with the table top. They are low by about 0.4mm. So a created a ring shim that installs nicely on the back of the insert rings. I made it 0.4mm thick but you…
The original tee likes to break, so I designed this based on the remnants of the original. I test-printed from PETG, but it tolerates the prevailing temperatures poorly. I recommend using a more durable material.
Rear plate for your Toyota Hi-Ace or other 2RE motor. Mine rusted though and had a pin hole leak, will result in a leak around the right hand side of the transmission body. Toyota sell them for <$20 but are often 4 weeks out so this will…
This cable holder replaces the BMW OEM clip 33 18 1 181 218 (33181181218). It routes and secures wiring on the suspension—typically the brake pad wear sensor at the rear, and in some models also ABS/signal wires—so cables don’t chafe or…
My OEM fences would swell up from the year-round humidity, so instead of buying replacements, I designed these. Print Settings Printer Brand: Ultimaker Printer: S5 Rafts: No Supports: No Resolution: 0.15 Infill: Any Filament: Any Any Any…
