Counting matching models…
Box: https://www.distrelec.de/de/robustes-scharniergehaeuse-x8-110x260x100mm-grau-transparent-abs-ip66-ip67-camdenboss-chdx8-322c/p/30113298 Heatsink: 150x13x100 must cut to 150x13x66 150*13*100/200/300mm Aluminium Kühlkörper Kühler…
The goal was to keep the original placement of the receiver box and provides an addition 10mm clearance for the larger 4274 motor. BOM m3x20 2 m3x30 2 5x3mm foam m3 inserts 6 Print Support: Yes Material: PLA
I needed an osVAC vaccum adapter for the Fanzwork EZ150A Orbital Sander and didn't find any fitting ones which used the original pipe delivered with the sander.
model provided to me by spintend, thanks amy
Model provided to me by Spintend - Includes both the Vertical Phase Wires and Parallel Phase Wires configurations of the Ubox 85v single VESC controller. Controller heights match the specifications from their website. Thank you, Amy!
These old Porter Cable nose cushions eventually just crumble. They do sell replacement parts online, but they are pretty pricey for a simple part. There was one other model on here that was a replacement for the very similar nailers…
To construct the case, the battery is placed into the print near the end (at layer 383 when using a 0.2mm layer height), and the print is then resumed, fully encasing the battery. The weight of the print is 6 grams, bringing the combined…
This needs to be printed in something heat resistant like PETG or ABS, PLA will most likely deform due to heat from the ESC. Glue the fan cover on the upper casing with CA glue. Use the 4 standard small screws from the old case to fit the…
Isolation cap for battery terminal 150A
Arrma 223s ESC mount adaptor for Spectrum 150A ESC
Freecad file contains 2 models, original → as close as possible to original as I could measure some of smaller hole sizes might be wrong as they were hard to measure, also the draft angles were ignored, and second model → optimized for…
My little 1 Gallon Shop-Vac MC150A had no hose (4 ft x 1.25 inch hose pn#90564), so I made an adapter to use my Big Shop-Vac Hose on the little one. Works very well. This makes 2 ½ inch hose fit into 1 ¼ inch receptacle.
Ultralight cover for Vapcell 2150A 5000mAh powerbank. It blocks the positive and negative contacts of the battery leaving only USB-C connection available for backpacking use. Only weighting 3 grams total! It is printed as two separate…
