14 models
Soporte de Montaje con Ventilación para JK-BMS (300A) Este es un soporte robusto y funcional diseñado específicamente para la JK-BMS de 300A (modelo JK-PB2A16S30P ). El diseño eleva la BMS para permitir un flujo de aire constante por la…
BOM required : ESP32 CMT2300A dev board with “E49-900M20S” chip OLED 0.96" screen “SSD1315” Dupont connectors External “868MHz~915MHz Antenna” with an IPEX4 <> Female SMA cable Use “Snug” support for both part and add “build plate only”…
Case (top and bottom) for OpenDTU hardware Printed on genius pro 0.2mm no support 2.5mm screws are needed to close the case. I used 2.5mm insert to attach ESP32 to the bottom (insert are heated thanks to soldering iron) You have 2…
This accessory was present on E-11 and E-11 variants in Rogue One, Solo, and The Mandalorian.
Edit 14-Apr-2023 - New version here: https://www.printables.com/de/model/452067-case-for-sunlu-3d-pen-new-functional-design Used Walter's SCAD model to build my case for Sunlu SL-300A Digital 3D Printer pen. Remodelled the lid with emblem…
Thanks for the design. https://www.printables.com/model/7025 I didn't want to install any LEDs, so I closed the holes.
A simpel bracket to mount the Victron Smartshunt 300A to a wall. I don't know if the 500A version will fit.
A suction adapter fitting the Bosch PEX 300AE Orbital Sander, equipped with an osVACneo M32 Male connector.
Screwable accurate model of the Famous M-300A flashlight. Mainly used on E-10 / E-11 / E-22 blasters. Optimised for resin printing with small details but can be printed on FDM. M3 screw can be replaced by real M3 Hex Rounded screw. Use a…
Added wall mount with two 3x screw holes
Seaflo 300A battery switch mounting adapter - Used this in my sprinter camper van build Printed in PA-CF. Added M5 inserts in the back.
Simple spacer to go underneath these reasonable bus bars. Designed for two purposes - allow wiring to pass beneath the bus bar and to height match to the smart shut so that copper flat can be used for high amp interconnects. Pass through…
Print with whatever settings you want. then bend all 4 tabs straight. Remove the original brass inserts, reinstall them into the new piece using a soldering iron. Then put the metal piece with the bolt still in it into the new part. Bend…
Made a simple mounting base for DC circuit breaker used in PV installations and energy storage systems Link to aliexpress: https://pl.aliexpress.com/item/1005006149911452.html
