Counting matching models…
Update 16.4.23: Step-Files uploaded Open Cable Chain with Clip 30x40x20mm Print Settings Printer: Geeetech A10 Rafts: No Supports: No Resolution: 0,2mm Infill: 30% Filament: Das Filament PETG Category: 3D Printer Accessories
Am besten mit TPU drucken, damit er fester in dem Rohr sitzt.
Multiboard is a creation of Jonathan (Keep making). See his entire project at Multiboard.io This uses the push fit connection method in a snap ring. As with all things Multiboard, print at .2mm layer height, 15% infill, and 3 wall…
Dieses Modell ist ein Einsatz zum verschließen der Griffmulde in den Euroboxen der Größe 30x40cm von Bauhaus. Ich habe drei andere Modelle gedruckt. Leider war bei allen der untere Radius ein ganz anderer als an meiner Eurobox. Deshalb…
Used to cover a steel pipe for a table. History Version 0.1.0 First published version and currently in use. Print instructions Rafts: Yes Supports: Yes Resolution: 0.4mm Infill: 100% Filament: ASA or other
Just a small case. I used it for a PWM controller. You may use it for something else. Just take the back cover and modify it. It is also intended to slide PCB boards inside, for DIY applications. Case mount screws are M3. Front screws are…
Karosserie-Pad 30x40 SW13-T5 02 Ausbeul Pad wird nach einfügen einer M8 Mutter oder Schraube an entsprechende Stelle in leichte Beule des Fahrzeugs geklebt. Durch ziehen am befestigten Pad wird versucht die Beule zurück zu ziehen. Danach…
I had wooden bars 20X40 and had no time to buy pipes. I made this model and decided to share. I used three holders for one shelf 1.5 m long. I added .3mf in it at once a set (mounting on a wall, modified by the author -…
Quick and easy print should fit exactly. The screws pulled from another quick attach plate that was the wrong size from Amazon. I printed it inverted so that the part that would normally touch the camera is the part on the build plate and…
This is a spoolholder for regular 30x40cm Eurobox (just short of 27x37cm inner measurements). Although you might get away with using as low as 22cm as Box height, I recommend using 23.5+cm for standard 1kg Spools, especially if you are…
print standing up. for 30x40mm cards. no supports needed.
Quick and easy print should fit exactly. The screws pulled from another quick attach plate that was the wrong size from Amazon. I printed it inverted so that the part that would normally touch the camera is the part on the build plate and…
