6 models
These are some 3D printable cam covers modeled after the ones on the Toyota 16V 4AGE. This is mostly just for funsies/decoration because I doubt the features are going to be accurate enough to use as a reference. The models are 1:1, so…
Get rid of the factory idle speed control valve, or auxiliary air valve as Toyota calls it. The OEM valve when cold idles the engine around 2000 rpm which is very annoying when your aftermarket exhaust is super loud. Mounting hardware is…
Print two of each of the end and middle ones. The extensions are separate to glue on to save support material. Also attached full length ones. Print settings: 0.2mm, 40% infill, ABS recommended
Limited access on cars like the AW11 MR2 always made installing cam seals in vehicle a pain in the butt. With this tool a bolt can be used to push them in perfectly straight. Suited to the 4AGE cam seals which are 35mm ID and 49mm OD.…
These are the engine bay intake hoses for the MK1B AW11 MR2 NA. I am currently successfully using the throttle body hose with no issues out of TPU(1600 miles) sub freezing temps and over 95 degree summer days with hard driving. I also…
