Counting matching models…
6025 Fan Holder for Control Board I used Noctua NF-A6x25 5V PWM Bambu > Noctua Dark Gray>Black (GND) Black>Yellow (+5V) Light Gray>Green (RPM/Tach) White>Blue (PWM)
This is a remix of my remix of the "Kobra Go PSU (Chengliang P400W24V) Hex Cover for Noctua 6025" for using it with the stock fan the PSU of the Anycubic Kobra Go/Neo/Kobra2-series comes with ("Cheng Liang CHA6024RL-15B", 400W, 24V) where…
Reduced the number of fan mounting points and lowered the fan position to better make us of the back panel opening. For a 60x25mm (6025) fan, I used the Notura NF-A6x25 PWN 4 wire (don't use the Low Noise Adaptor as the fan sometimes does…
Crazy blow fan duct Ender v3 KE fan 6025, too lazy to explain... in short, the connectors are parallel, can be re-soldered or wound onto one plug. The blowing power is enough for anything at all. Print naturally ABS.…
I did a remix for 4022 from same model. A community member asked me if I could do one for 6025 Fan, so here it is. I don't have a 6025 so I can't test the fit but should work. I did print one and seems it will work. Use the connectors…
Why? I never understood why the RC community loves to use 4010 fan and cranks them up to crazy RPM just to provide some cooling, additionally for us bashers, they are of no use, since those tiny wings tend to break quite early. Features:…
I made an extremely unnecessary upgrade to my Kobra Go PSU to make it quieter at idle and fit a noctua 6025. I'm a Noctua fanboy, and this fan at 12V gives almost the same CFH as the stinky one that was in there already. I just cut the…
I'm adding fuzzy skin to the "required" list, it helps immensely with PETG. Unknown for TPU but I assume it's the same. This is a replacement for the rubber fuel pump mounts/collars for the Jaguar X300 (XJ6/XJ12/XJR). As I recently found…
This frame supports fan 2x4020, or 4020&6025
This model is compatible with the lego system.
This upgrade uses 6025 Elegoo fans and does require modification to the fan circuit to ensure the F3 fuse 1A limit is not exceeded.
Remix of rear cover for Qidi Plus 4 – fits 6025 blower(60x60x25mm)
Biqu H2 Lite Part cooling 6025. 6025 should provide enough air to cool print at higher printing speeds. Besides, it is quiet. Print at 45 degrees.
This model is compatible with the lego system.
