Counting matching models…
My new pool robot, the Aiper Scuba SE, is already doing a very good job, but the result can be improved by adding filter balls to the suction chamber. There are some suggestions for this on the Internet. Unfortunately, the filter balls…
In an above ground vinyl pool with curved bottoms the Aiper Scuba tends to get stuck bouncing between the same walls, if this happens with your pool and Aiper print 3 of these and stick on ONE of the outlet ports for the water jet, these…
Unfortunately, the Aiper Scuba SE does not have a cover for the power connection. And as it comes into contact with chlorine and other chemicals most of the time under water, I quickly designed a cover made of TPU.
What is this thing? This mod replace the Soviet Photosniper kit's trigger mechanism to a normal mechanical shutter release cable. What's being replaced? Top plate of the stock and the trigger pack. You will have to drill a hole on the…
No supports needed. Around 30% infill and 4 walls should be sufficient. I recommend using at least PETG though PLA-Plus may work too. Should the focus ring be difficult to turn after assembly, screw in the Tairs focus limiter screw a bit…
Aboveground pools don't often have completely veridical wall faces and in these cases the Aiper skimmer's wheels do not make contact with the wall. These "bummers" give a little bit of extra space and keep the skimmer from rubbing the…
Klappe für den AIPER Scuba SE Poolroboter
