Counting matching models…
This is an ok sounding portable Airplay speaker. Print instructions I printed this at 0.3 layer height with no supports because I'm impatient and I knew I was going to paint it. The USB C charger board is a real tight fit, once your…
Raspberry Pi Boombox In this Project we’re using a Raspberry Pi Zero W to make an AirPlay-ready audio player. With shairport sync, you can stream audio from an iOS device to the Raspberry Pi. We think this is a great little airplay…
These are the printable parts required to build a "Speaky". I created this case to hold a set of desktop speakers and a Raspberry Pi that I'm using as an Airplay receiver. I based the case design (loosely) on some mid-century speakers I…
Wallmount for Bose 1st. Airplay Hardware: M4
I added a space for small relay module for turning on and off the speakers power. You can use Squeezelite for exaple i think, or it can be used with HA to control the relay.
This is a very simple stand for a Belkin AirPlay 2 player. It was quickly thrown together on TinkerCad, then imported into Fusion 360 to add the fillets. The “slot” is a slightly off center, but good enough for what I needed. I printed it…
