7 models
There are a lot of Funnels out there, but i want an easy print Funnel in a short time, for 2-3 uses. So i made a simple one. Made with Tinkercad Sliced it with Cura Spiral version 33 min to Print
Print approx. €0.40–€0.48 excl. taxPreliminary estimate for one variant
The latest revision of the airtube to mount a 40mm fan on a Serpent X20. It creates a 2mm gap around the motor, creating a air flux and allowing to pass the ESC cable above the motor and getting it back just beside the receiver. Print…
This version use the optional fan shroud fixation but it allows to use a 40mm fan and to hide the ESC cable. You will need two m3x6 screws to fix it.
Version 1: 104mm Outer Diameter / 100mm Inner Diameter Version 2 102,5mm Outer Diameter / 101mm Inner Diameter Printed: PLA
Holds the airtube for the pandaplacer in the middle of the pandaplacer frame. Needs two 2020 profiles that are hold in place using the included cornerbrackets. The tube is held in place using two rubber bands.
The pipe inside the Yamaha BC3 breathcontroller headset that connects the sensor and the flexible airtube can break and parts are hard to find. I reverse engineered it and have used it to repair a couple of these headsets already. I've…
