4 models
I liked the original design because of its clean surfaces and edges. I've just tweaked it a little bit and added the base for the ApexEVO frame. !IMPORTANT!{begin} The gap between the front propellers and the mount is about 6mm. I haven't…
There are two versions. The only difference between them is the extra cut-out for the recording-light above the front screen of the GoPro. Check that there is enough clearence between the camera body and the front propellers!
This is for the Happymodel EP1 and EP1-Dual antennas. As shown in the picture you can make a small cut to make inserting the antenna easier.
This design is for the Flywoo action camera case V2.1 for a naked GoPro. I've uploaded different angles. Starting from 10 degrees to 35 degrees, with 5 degree increments. To make it easier to identify the angle once printed, it is stamped…
