1 / 3
ImpulseRC ApexEVO GoPro 9/10/11/12 Mount
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
GoPro mount for the ApexEVO frame with a 20° angle.
- Rating
- 5 / 5
- Likes
- 10
- Downloads
- 246
- Makes
- 1
- Views
- 1,174
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I liked the original design because of its clean surfaces and edges. I've just tweaked it a little bit and added the base for the ApexEVO frame.
!IMPORTANT!{begin}
The gap between the front propellers and the mount is about 6mm. I haven't experienced any issues yet, but I think it might be possible for the propellers to bend and touch the mount under heavy load (e.g. recovering out of a dive). The angle should prevent the propellers from cutting into the TPU but I've also made a version with a 5 mm higher base.
!IMPORTANT!{end} 😉