10 models
Backshell for Canon 25 connector (LPT, COM, etc). Krytka pro konektor typu Canon 25. Print instructions Backshell for connector Canon 25 (DB25). Used for LPT or COM - 25. Three versions, for cables: ø = 5 mm ø = 7 mm ø = 9 mm Fasten…
I was unsatisfied with the backshells available for download, and I had none handy, and I figured it wouldn't be a tough build. These clamp together nicely and are locked together by the SHCS when assembled. They fit Tayda D-sub…
Low profile housings for old school DB style connectors, with a variety of holes for cable sizes. They snap together and don't need any nuts or screws. The numbers in the variations are the intended cable diameters, in millimetres.…
Another D-Sub housing? Actually I was surprised to not find more and better models out there already... D-Sub connectors are quite commonly used and I usually have the connectors in my junk-boxes. But what about the housings? For the…
90 degree backshell for DEUTSCH DT06-12SA-P012 used on for example agricultural GPS receivers. An adapter for a M16 with 16mm outer diameter corrugated pipe is included in the back of the shell. Also included is a clip on dustcover for…
Lots of new features added compared to the original V1 model, including: 1.) A full size heatsink ( no need to get rid of some finstacks to lower the fan into it) 2.) A bigger 40x40x10 noctua fan, 3.) Docked turbo mode ( utilizes 5 volt…
Slide onto back shell with pre applied adhesive. Thread McMaster 95966A723 in for locking features.
This felt silly, because these lamp-holders are so cheap, but I didn't want to purchase 8 of them, and thought others may benefit from the design work as well. It repairs a lamp holder of this style:…
Space requirements meant I needed a backshell for a D-sub connector that had side entry cabling and a small footprint. It come in two parts that are glued together. The cost of 2 screws is 4x more than the plastic, so it's pointless…
ESCALAR AL TAMAÑO DESEADO Utilizar soportes en árbol.
