10 modeli
Low profile housings for old school DB style connectors, with a variety of holes for cable sizes. They snap together and don't need any nuts or screws. The numbers in the variations are the intended cable diameters, in millimetres.…
Another D-Sub housing? Actually I was surprised to not find more and better models out there already... D-Sub connectors are quite commonly used and I usually have the connectors in my junk-boxes. But what about the housings? For the…
Backshell for Canon 25 connector (LPT, COM, etc). Krytka pro konektor typu Canon 25. Print instructions Backshell for connector Canon 25 (DB25). Used for LPT or COM - 25. Three versions, for cables: ø = 5 mm ø = 7 mm ø = 9 mm Fasten…
I was unsatisfied with the backshells available for download, and I had none handy, and I figured it wouldn't be a tough build. These clamp together nicely and are locked together by the SHCS when assembled. They fit Tayda D-sub…
90 degree backshell for DEUTSCH DT06-12SA-P012 used on for example agricultural GPS receivers. An adapter for a M16 with 16mm outer diameter corrugated pipe is included in the back of the shell. Also included is a clip on dustcover for…
Lots of new features added compared to the original V1 model, including: 1.) A full size heatsink ( no need to get rid of some finstacks to lower the fan into it) 2.) A bigger 40x40x10 noctua fan, 3.) Docked turbo mode ( utilizes 5 volt…
Slide onto back shell with pre applied adhesive. Thread McMaster 95966A723 in for locking features.
This felt silly, because these lamp-holders are so cheap, but I didn't want to purchase 8 of them, and thought others may benefit from the design work as well. It repairs a lamp holder of this style:…
Space requirements meant I needed a backshell for a D-sub connector that had side entry cabling and a small footprint. It come in two parts that are glued together. The cost of 2 screws is 4x more than the plastic, so it's pointless…
ESCALAR AL TAMAÑO DESEADO Utilizar soportes en árbol.
