Counting matching models…
A simple, single use mount to hold a Bigtreetech ADXL345 or S2DW accelerometer for input shaper calibration of the Y-Axis on bedslinger printers. Print in the center of the bed, then attach the sensor. Print with Brim for extra bed…
For one of the most common generic type of ADXL345, see picture (15mm screw hole distance and about 20x16mm PCB dimensions) Print the M3x4 or M3x6 model, once the print is done, set the bed to stay hot (don't let it cool too much or…
Works with: - ADXL345 - Fysetc Portable Input Shaper Mount Materials: - 2x m3*4mm screw - Any Rigid and sturdy filament with no flex (for accurate results) Instructions: Apply adhesive before printing, print in the desired orientation,…
Lay it flat to ensure the strongest print and eliminate the need for supports. I used PLA, and it worked well. However, PETG or ABS would likely perform even better. You'll need three T-nuts for 2020 extrusions, along with three M5 15mm…
DIY Project that utilizes out-of-the-shelf components and 3d prints. Fusion360 model: https://a360.co/3Ne5RhL Main Features: ~100x100x110 [mm] build volume Direct MK3s extruder remixed for MK8/HobbGoblin drive gear and filament sensor…
Prints with no supports. Ideally, print with the smallest layer height your printer supports to capture the small details of the model.
With this little thingamaboob you can mount your TWO TREES filament dryer box on top of your Bed Slinger or CoreXY printer, so you can print directly from above out of a drying device! no need for an additional rack above or behind the…
My CR-10 looked like it had been thrown together with cable management as a non-topic. so I made these clips to secure the cables to the 20mm aluminium extrusion frame. Nothing fancy.
Rigid bed mounted dock for Klicky00 . This dock allows you to pick up the probe by approaching it from above, but only allows the probe to exit from the Y direction, which helps preserve the plating on the klicky magnets compared to my…
All printed parts made of PETG, Ball bearings press fit into the ends of the rollers and optionally held to the bolt's shaft with some retaining compound, Beech or birch plywood preferred. Additionally required: 2 M4xL5xOD6 mm heat set…
This part contains 2 parts, an angled extrusion that interfaces with the other part, a small base that interfaces with the mounting of the USB webcam. The base has 8 bores, 45 degrees apart so the insert can be turned at any angle that…
This is a Remix of this model I integrated the model basically a custom linear rail using a 2020 or 2040 as the rail and this model as the carriage into a Voron 0 bed plate to mount a 120mm Voron 0 bed and use it on a y axis for a custom…
