Counting matching models…
If you own a Retroleum SmartCard V2 or V3.1 from Phil ( http://blog.retroleum.co.uk/smart-card-for-zx-spectrum/ ) you may look for a nice case. There is one case available from Johan at https://github.com/SM7I/SmartCardv2 , but it doesn't…
Prints without supports. The arches can be more or less satisfactory, depending on the print quality, but it's easily fixed with sandpaper.
Je l'ai fait plus haut afin de pouvoir passer une bouteille de sodastream ou une gourde. On peut également utiliser l'espace en dessous pour y ranger quelque chose. I made it higher so I could pass a bottle of sodastream or a water…
Here's a fun little novel CyberKey to add to the collection - a Funbie Studios logo-ed one! Sporting a very gear inspired motif, aligned with our design sensibilities, this "branded" CyberKey is sized similarly and works just as well as…
I needed to build a new Berkey double bucket filter, and I decided to use all Gamma seal lids. However, the gap between the bottom of the top bucket and the Gamma seal lid caused leakage due to not getting a good, tight seal with the…
It is a simple stand I made for my Alexa Pure water filter in order to make it easier to get cups under the spout without having to put it on the edge of the counter. Its been a while since I printed it so I dont remember what settings I…
Pokud se vám model líbí, budu rád za váš like. If you like the model, I would be happy for your like.
Stop buying expensive disposable filters! This is a sustainable, refillable water softener cartridge designed for gravity water systems. Specifically designed for Purewell K-Series charcoal filters, it also fits many Berkey style systems.…
My Big Berkey Water Filter was tilted from sitting on the rim of the kitchen sink. I made these shims so my water filter would sit flat and level. When you print it you need to make sure the first layer is secure to the platen. After the…
This is designed to raise the Berkey Royal Water Filter a little and let it sit over the lip of our kitchen sink. This helps the spout to stick out over the sink a little more and be just high enough to make filling cups easier. It also…
Simple stand to raise the Big Berkey on your counter. Print instructions Designed to fit the Big Berkey, but should work for any size if you resize it for your Berkey's base diameter. Printed without resizing, it's a smaller diameter than…
I needed a new nut for a Berkey filter, I designed and printed it in ASA 0.16mm 100% infill
This bracket allows you to secure a Berkey Travel canister, resting on a table of appropriate height, to an 8020 40-series rail with 1 x M8 T-slot bolt and a 10-in bungee cord. The part is designed to use one M8 star-shaped knob with a…
After printing faceman's Big Berkey Stand (https://www.printables.com/model/3154-big-berkey-stand) I found that it very easily slid around on top of the mini fridge where I have my water filter unit set up. I designed this specifically to…
