Counting matching models…
Actuated joint for camera arm https://www.prusaprinters.org/prints/3407-articulating-raspberry-pi-camera-mount-for-prusa-m using a Bipolar Stepper motor and cycloidal gear from https://www.thingiverse.com/thing:2669441
28byj-48 stepper motor is a unipolar stepper. But to use it with better drivers that allow microstepping you need to modify it by cutting the center trace on the PCB inside the motor. Then you can drive it as a bipolar motor with drivers…
This model was printed in PLA first to test, and then printed in ABS. The interior of the model was fill with silicon to ensure it was complete seal. The tail model was printed in TPU from PRINTALOT. Thanks 4 passing by.
Mounting block for 3V, 1.6A, 233 oz-in Geared Bipolar Stepper Motor with attached integrated Planetary gearbox with a 52/11 :1 ratio. Instructions Printed in ABS with 0.2mm layers. I had to clean out the bolt holes. Used 3mm flat head…
Mounting block for 3V, 1.6A, 233 oz-in Geared Bipolar Stepper Motor with attached integrated Planetary gearbox with a 52/11 :1 ratio. Instructions Printed in ABS with 0.2mm layers. I had to clean out the bolt holes. Used 3mm flat head…
