Counting matching models…
This places the center of the chuck in the anchor 2 (0, 0) position. Print the subplate on an angle (30 degrees is ideal) to given it higher shearing strength, and be careful when installing the chuck to not over do tightening it. The…
Joe N style alignment, where instead of pins it uses the anchor, makes it much easier to cutout. Just make sure to apply pressure towards the anchor2 corner while screwing it down. The bolt needs a M14x1.00 thread to secure the chuck from…
Based on a cylinder seeling I drew up a spacer for in between the cylinder and the motor-housing. It's available in different heights. The idea is to use this to figure out which exact spacing you need, then you can order the one you need…
This places the center of the chuck in the anchor 2 (0, 0) position. Print the subplate on an angle (30 degrees is ideal) to given it higher shearing strength, and be careful when installing the chuck to not over do tightening it. The…
Joe N style alignment, where instead of pins it uses the anchor, makes it much easier to cutout. Just make sure to apply pressure towards the anchor2 corner while screwing it down. The bolt needs a M14x1.00 thread to secure the chuck from…
My filament swatch box with 6x2 magnets. v2 - added window to see samples when box is closed
