5 models
This is a wallmount made for holding brewtools and gardena tubing. The top five slots holds Brewtools 16x25mm silicone tubing: The bottom three slots holds normal gardena tubing with 16.5-17mm OD Screws to the wall with two 4x20mm pan…
A slimline cage for the Brewtools touchscreen. Honeycomb pattern for good ventilation. Vesa hole pattern on the back piece for Vesa 75_75 and Vesa 100_100. You also need 16 pcs m5 threaded inserts for 3d prints (6,3mm OD), 4 pcs m5 12mm…
Wanted my Brewtools B80 to sit a little bit "softer" on my bench. Printed in soft TPU, no supports needed. You would need 6 side pieces, 1 front piece and 1 rear piece for full coverage around the lower rolled metal edge. But you can…
Wall mounted holder for your BREWTOOLS Mash probe. Really useful if you use the screen re-location kit and want to park your mash-probe close to your screen.
The suction feet on the small Brewtools pumps was not enough to keep them in place in the glycol chiller so i made a small mounting board which i could zip tie to the bottom. Printed in PETG with 25% infill and 0.15 structural. No…
