Counting matching models…
This is a printable zero clearance throat plate for the Ryobi BT3000 Table Saw. This is version 3 of the throat plate and should work as printed for most cases. I am working on a v4 that will have a joint for providing a more robust…
Blank router table insert for the Ryobi BT3000. Can be used to block off the opening or modified / cut for router use. You may need to scale just a bit for the desired fit.
Honestly, I haven't even sawn thru my original end blocks yet. I just read about folks who were looking for replacements, so I wanted to try drawing these up. Then I found that someone on Thingiverse had already done it. Oh well - I think…
Replacement end caps for the Ryobi BT3000 table saw. This should not require supports if printed on the 45 face as shown / downloaded. Note that the left and right caps are mirrors of each other so if you only need one, make sure you…
This wheel can get its center slot-hole stripped if you try to turn it too hard as it is the only non-metal piece involved in the blade raise/lower mechanism. Lubricate your bevel gears! It's a tight fit and I had to file both the crank…
Printed in PLA at 35% infill. I used tree supports for the overhangs, but not sure they are necessary.
This clip fits under the sliding miter table. it is the clip that fits closest to the table rides on top of the aluminum rail. I printed in PLA and it slides fine but Nylon may be a better choice for longevity. Category: Machine Tools
