Counting matching models…
Hallo, ich habe hier für eine eBike Bosch Mini Remote BRC3300 ein Reparaturschelle konstruiert. Das Original ist leider gebrochen, ein Ersatzteil gibt es vom Hersteller nicht. Gedruckt in PC ist es stabiler als das Original. Auf der…
This is the cap for the 80mm Mamiya lens. I obtained a good result with PLA and 0.4mm nozzle (0.2mm layer). Enjoy!
This is a lens hood designed to fit the 80mm lens for the Mamiya C220 and C330 family of twin-lens-reflex cameras. The dimensions are roughly worked out from online images of the original metal hood. The diameter of the clamping section…
Slide on offset step-up ring to 58mm thread for Mamiya TLR (C330, C220). Tested on 80mm f/2.8 and 105mm f/3.5 lenses. There is no thread designed for 58mm side, but print surface provides enough friction for a snug fit. Print is done in 2…
A gridfinity bin to hold the complete internal deburring tool set, RC3300 separate cutouts for the RC1000, RC2000 and RC2200. Also has a storage cutout for spare blades (that I don't have so it just takes up whatever room is left over) My…
Protect That Lens This is a simple lens cap that I whipped up for the Mamiya C330 tlr. This should work with most lenses available for the C330 and C330 compatible lens assemblies. It has a friction fit so you may need to tweak it a…
Lens Cap for Silver 80mm 2.8 Could be that you have to scale it to compensate the shrink of the filament
Vacuum cleaner brush spare part for Kerch Delta VC3300
A very simple bolt handle replacement for the AKBM C330 single shot pistol
W plikach znajduje się mocowanie skrzynki bezpieczników wersja Rev00 najnowsza, które w moim przypadku zostało zastosowane do Ursus C330. Mocowanie podnosi nieznacznie całą skrzynkę przez co przewody nie wystają tak nisko. Całość…
Lens Cap for Silver 80mm 2.8 Could be that you have to scale it to compensate the shrink of the filament
I found a defective C330. It would be a shame to throw it away The drive gear for the film spool and the leathering on the crank side were missing. I reconstructed both in Blender. The camera now works. Category: Other
Ran into a "slight issue" where my grip tore out of my FC330 in the middle of a game, after a little headscratch I realized that mine must be an older revision. Checked it relative to a friend's blaster and found that it was missing two…
I was looking for a bracket to mount Bosch BC330 charger on a wall in my garage. The designs I found offered mounting it vertically. There are two problems with this because the charger was not designed for such application: (a) the…
Jest to statuetka dal fana rolnictwa. Posiada ona napis C330 który każdy rolnik powinien znać.
I printed this in TPU filament on an Ender 3. This fit on my Sekor 80mm lens. It could fit on other lenses with a diameter of 48mm.
A Slat Wall plate for the Bosch BC330 Battery Charger Mount ( https://www.prusaprinters.org/prints/76609-bosch-bc330-battery-charger-mount ).
A wall mount for the Bosch BC330 Battery Charger ( https://www.amazon.com/Bosch-BC330-12-volt-Lithium-Ion-Battery/dp/B00EPE7QU4 ). I've also designed a Slat Wall plate for this mount:…
