Counting matching models…
A small concertina-shaped rosin case, modeled after a pre-WW1 anglo-german concertina by Charles Jeffries. Printed in two colors (black & silver). I also tried using layers and different colors to make the end-plate and buttons a bit…
This is a very old model I made as a substitute for all the other wargaming miniature razor wire options I had seen before. This prints a very long section that can be cut to any lengths needed. As you can see in the closeup of the 3d…
Clock and Concertina Springs to use in your parts Basics here so may need some work a bit rough. Experiment shows PLA is not too good for these. Uses springy filaments Category: 3D Printing
my grandpa's old watch stopped working, its not something i wear on the regular so i didn't want to spend a lot on sending it to a repair shop and doing it myself seemed easy enough. after printing a few tools made by other i realized…
Required Materials: ALL-WEATHER DUCT TAPE (1.88 inch width) SILICON TUBING (5/16" Outer Diameter, 3/16" Inner Diameter) Optional Materials: Gaffer Tape for the straps (Note: gaffer tape is not airtight enough to work well as bellows) Main…
