Counting matching models…
PS: don’t try this unless you are sure of what you are doing! This is a major modification of the printer! I have had a leapfrog printer for ages, it always bothered me that the dual extruders prevented me from using the full build plate.…
Uppdate 24-11-2015 ( I have uppdated the bearing blocks. https://youtu.be/QRKUzB4lhs4 The top rail is not nesseseary, the machine works perfectly, but beacause of the orifginal Creatr design the motor shafts keep failing due to metal…
I made the excellent ninjaflex spring loaded exstruder mods referensed from eliscott02 a while back. It got a bitt wobbly after some use, so i made a more sturdy version with a little better cooling access and for mounting dual pull…
After seeing how much the original setup vibrates during printing. I made a version of this for my Spring loaded exstruder. Its made a big difference on the quality of the prints, i no longer get a seam on small sylinders and items…
i got tired of unskrewing the fans every time i wanted to get to my exstruders so here is a snap on version that you simply add the fans into and then lift the entire assembly off and put it back on in a few sec. Category: 3D Printing
i have been fixing and improving my Creatr printer a lot. Every single time i take off a side panel or something similar i need to re-adjust the bed, the machine moves a bit during assembly and disasembly. This dial holder holds the…
The right bearing is installed and its a massiv improvement in extruder carriage stiffness. This mod makes the y carriage a lot stiffer. I have had 2 Creatr Printers (both where damaged in transport) I have noted that the y axis is to…
The y axis easily gets out of alignment on leapfrogs creatr. Mount this block on top of the z axis lead skrew. on the right hand side. After homing the printer disable motors and pull it tigt against the block on the right side, voila…
X cariage for E3D Hemera on LeapFrog Creatr (Or other 60 mm rod distance 8 mm rod printer) Bearing holders mount to side of hemera, belt and cable guide and fan mount to front bearing holder. The Creatr uses 8 mm rods, 60 mm apart. The…
LM12UU are round but the space they fit in on a Leapfrog Creatr is square, so these replacements are square. They print in 2 halves. IGUS GSM-1214-15 should fit between 2 of these halves without pinching it against the axle. It should…
