17 models
Replacement for the DS2000 motor mount. This is a work in progress. My main PCB is dead, so I'm using an arduino which takes inputs from a thumbstick controller I made. It's not shown in this pic, but I recommend wrapping a thick elastic…
I picked up an old but mostly functional Meade DS-2102MAK telescope with Goto mount for my kid. The batteries had been left in it for years so I had to open up the mount in any way to clean it up and I discovered the worm gear on the base…
A remake to make the stand wider so it wouldn't slide to the side. It will print without supports. I used PLA and it takes about 4 hours to print.
This is a Uniden SDS200 Base Scanner Stand.. I printed mine in PETG 0.2mm layer, 3 walls, 15% infill.
If you like my design you can support me on BuyMeACoffee - https://www.buymeacoffee.com/kaushikbm -------- Tilt feet for Tektronix scope. Designed using FreeCAD. Print Settings Printer: FDM printer Rafts: Doesn't Matter Supports: Doesn't…
Case made with PLA, and the compartment mesh with TPU, all 0.20mm. Only use support on Lid for the recessed logo lettering To print the TPU mesh, choose an infill pattern (honeycomb 20%), 10 wall loops and set top and bottom shell layers…
Gehäuse für DS203 Speicheroszilloskop. Druckeinstellungen: Filament: PLA Drucker: Bambu Lab p1p Schichthöhe: 0.2 mm Supports (Orientierung siehe Foto) Case for DS203 oscilloscope. Print settings: Filament: PLA Printer: Bambu Lab p1p…
Supports for Meade telescope tripod DS2000 and other models. The OEM part had flimsy holes where it mounts to the legs with rivets. I made this more sturdy so it wont break. Take out original rivets with drill or pliers and replace with…
If you find my designs useful, please consider sending a tip . Update Nov 2025: Added a 2nd version which has recesses for adding an o-ring - Images online seem to show early versions of the mount used an o-ring, later ones like mine…
This is a simple holder for Pace ADS200 tip cartridges. Each hole has a diameter of 8.4 mm, because tubes have a diameter of 8.5 to 8.8 mm. Designed in FreeCAD 0.19.
The Pangea Audio DS200 speaker stands are hollow, and they will be greatly improved by filling them with dry play sand. The problem is both sides of the pillars have plates welded on them, giving only a tiny hole to pour sand through.…
DS200-125 Zigbee Door sensor mount
This is a screen for an ebike. Specifically, part of the Vinka mid drive system. These systems were available on some hyper ebikes sold in the USA and also some bikes sold by Conor in Spain (I think) as well as others that I am not…
HDD tray for Aerocool DS200 case, just a quick model of the existing hdd tray adapted to be used with screws. A very specific design but hopefully someone can make use of it. I use software which uses z as height there for alter print…
I made this for my PDU to hold the power supply and CD reader/CD's and board. This is what I used in this: Power supply Meanwell RD-50A (5VDC/12VDC)…
I bought this telescope at a thrift store like most people today have found them. I ran into a lot of issues with trying to print this worm gear. The IPT file does not work with mostslicers or even normal Fusion 360. so i went down a…
If you find my designs useful, please consider sending a tip Update Nov 2025: Added a 2nd version which has recesses for adding an o-ring - Images online seem to show early versions of the mount used an o-ring, later ones like mine didn't…
