Counting matching models…
Unchanged and added for the kit: higher_tensioner_spacer, interbearing-washer, lower_tensioner_spacer. The X-axis carriage is based on a CAD model from Henlor -https://makerworld.com/en/models/171995 The X-axis carriage with an oval hole…
To mount BIQU Microprobe to your Flying Bear Ghost 6 print this back cover and install it in place of the original. Print it from some heat resistant filament such as ABS. It is designed to be printed in a vertical orientation to make…
Attention!!! I do not know the distances from the back wall to the new silicone brush and the plastic drop-off point when CFS replacing filament. At the moment, I can assume that for the modifications with rails, it will be necessary to…
If you removed filament sensor from the left side of your Flying Bear Ghost 6 printer and remaining hole bothers you - plug it with this little part. No support is needed.
This model is an analogue of the original clip for fixing the cable connecting the print head of the printer. --- This m
Stojak można wykonać bez dodawania podpór ( powstanie tylko delikatny zwis pod napisem 110km )
Raspi-cam holder for Flying Bear Ghost 6. Haven't tried with thermal hat, might not be compatible.
Держатель филамента, из стандартной пластины от экструдера. Подойдет тем у кого переделано на Директ. https://www.thingiverse.com/thing:4805968 fiting holder thx this man Print Settings Printer: FBG5 Rafts: No Supports: No Resolution: 200…
Wydruk nie wymaga stosowania podpór
Держатель филамента, из стандартной пластины от экструдера. Подойдет тем у кого переделано на Директ. https://www.thingiverse.com/thing:4805968 fiting holder thx this man Print Settings Printer: FBG5 Rafts: No Supports: No Resolution: 200…
I needed to raise the printer by 10 cm to go around the plastic of the dryer at the right angle You need to unscrew the standard stops and screw them into the printed legs then screw the legs into place of the standard stops accordingly,…
Made to completely close the box of my ghost 6 Print Settings Printer Brand: Flying Bear Printer: Ghost 6 Rafts: Doesn't Matter Supports: No Infill: 10 or more Notes: Made to completely close the box of my ghost 6 Category: 3D Printer Parts
Slim dust tray for Flying Bear Ghost 6 length - 20 cm width - 15 cm height - 1.2 cm
