Counting matching models…
This modified version of the Datum PCB mount allows for 3D calibration using a second fiducial mark! You can find the necessary PDF for the second mark on the OpenPNP wiki here:…
Add this to your PandaPlacer A1 next to the up camera, and get full dual-level calibration abilities within OpenPnP. Follow the OpenPnP Issues & Solutions for the best possible calibration. Photo print a set of squares. Example file…
Show off how small things are with a 10mm² grid. Available in 100mm² and 200mm² sizes to fit most printers.
This is a holder for FRC apriltags from the 36h11 family. The width is the exact size of a letter size piece of paper. you can trim the bottom of the paper off for a perfect fit You should print this with support to prevent stringing, but…
Mount a smaller version of the LumenPnP's datum board, without moving the primary fiducial, to enable 3D calibration. This is second revision of this model, moving the secondary fiducial to OEM secondary fiducial location, removing the…
OpenPnP Fiducial Riser Platforms to put OpenPnP fiducal targets on, 24mm and 34mm high.
The Fid Tool is a square flat tool intended to assist the operator in accurately marking the position to place a bar code, QR code sticker or similar on the robotics floor. These are known as fiducials at sites where robots use a grid of…
Show off how small things are with a 10mm² grid. Available in 100mm² and 200mm² sizes to fit most printers.
The Fid Tool is a square flat tool intended to assist the operator in accurately marking the position to place a bar code, QR code sticker or similar on the robotics floor. These are known as fiducials at sites where robots use a grid of…
