20 models
Foam Board hybrid RC plane designed to help teach my grandchildren how to fly (interpret that as strong but it won't bother me if I have to make multiple). It has an under-cambered wing, so it is a slow flyer (which is also good for…
These corners are designed to allow you to make a hinged box up to any size foam core board that you have with no glue required! Scaled to use standard Dollar Store size foamboard, I believe it could also be scaled to work similarly with…
If you're a fan of foamboard airplanes (like the popular Flite Test designs) you know that the usual way to mount servos into the foam is with hot glue. This works, but it's difficult and messy to remove the servos for repair or…
3d printable parts to aid in a lightweight multi prop fixed wing RC plane. Wing and fuselage may be built using common foam-board technique (see Experimental Airlines in YouTube, or wait for my more details plans to come out after a bit…
Not intended to be very strong as there's no corner chamfers, but instead just to fit foamboard pieces together. Made with PLA shrinkage in mind.
Used to make foamboard RC planes, just add an M3 bolt and nut and utility knife and you will be cutting perfect bevels!
These little and eays to print legs can be used to present a foamboard poster at a small angle. Because the legs are so small, it is possible to print them in high quantities (they also require no support material). The maximum thickness…
EDIT: 4 July 2022 I've updated my remix of the Ikea Lack Enclosure (redone in Fusion 360) and have uploaded the Fusion 360 project file for anyone who wishes to customize it even further! While my Fusion 360 skills are still far from even…
Pairs of these can be added to the original foam board box made with the corners this is remixed from to create divider walls within the same box. Print these with supports, 20% infill, and 2-3 layer walls.
Per costruirla ho usato: Sbr12 guida lineare da 1 metro 2 pz t8 vite trapezoidale da 1 metro 2pz , ma va bene anche una comune barra filettata da m8 4 pezzi di barra rettificata da 8mm (non più lunghe di 500mm perché sennò oscilla) 4…
Designed to protect the corners of foamcore/foamboard posters and sheets when they are being moved or stored. Two small pieces of masking tape on the back hold it in place and don't mar the poster surface. Comes in three different sizes…
After several months of successful, summer printing, fall/winter is here and it is apparently too cold to print :( I needed something quick and cheap, so I decided to throw together an enclosure made of 1/2" insulation foamboard. It's not…
An easy to make sail made of 3mm depron for small boats/yachts/sailboats... use the same sail plan as on the "simple rig" and extend it at the bottom (foot) Happy sailing ;)
This is a hold down and an aligner for holding foamboard or depron sheets in position when using the TimSav needle cutter. Made to use M4 screws or any screw smaller than 4mm.
front for a foamboard plane
Simple leg for holding a photo attached to foamboard. It's 5 degrees, about as vertical as you can get away with. Print two, then connect them with a 4mm stick e.g. a kebab stick cut to size.
Simply system for non permanent mounting of photos to 5mm thick foamboard. Take the guide, and using a cheap hole punch (mines from Harbour Freight) punch the desired holes into the corners of the board. Punch 9/64th (3.5-4mm) holes. The…
