Counting matching models…
This remix is fully redesigned to get rid of the glueing, is fully retractable under the table and the shaft can be printed laying flat.
A simple hook. Flat back; can be mounted with glue or mounting tape. 50mm tall, 20mm wide, 32mm overall width, about 20mm internal width. Dimensions can be adjusted easily by scaling in the slicer. Made for headphones, but good for…
The insert fits into the Brogrund toilet paper holder by IKEA. It creates a flat surface which makes it easier to apply double sided tape or glue to stick it to the wall. The bigger surface area should ensure a tight bond and you can skip…
Filament - Any Printer - Any Bed adhesion - No brim or raft required Support - None This is the first model I have ever published so would appreciate it if you could comment or post a make so that I can see what you have used my model for.
If you have dusty filament it can show up in the print. This removes it. Use 8 pcs of 4x2mm magnets, just push them in. No glue needed. Doublecheck the magnets have the correct orientation, especially when you do the second half. This is…
Handy go game with a 9x9 and 13x13 surface to be played with drawing pins, and drawers to hold the pins. The board will be printed in two parts and glued together. There are two options regarding the cross-pattern printing with ‘carved’…
Same electrics needed as the Original Model. Hardware changed: Needed Screws: 2× M1.6 6mm screw instead of the 10mm For Lid and Bearing guide 6× M3 8mm countersunk screws For attaching the Motorhousing to the body 4× M3 10-12mm…
I like to still cut the tape via boxcutter. Because thats what I always have in hand, when I use packaging tape in the first place. (fits for spool Ø 76mm) If you want to add a blade or something else, feel free to remix it :) Printing:…
It is rotating remote holder for 6 remotes. You dont need to use glue I have used a bearing from thingiverse: https://www.thingiverse.com/thing:53451
It s a great model kudos to CJ, i needed a higher brim so i extruded it. I also added clamps without holes for better adhesion with special glue. and one for slightly oblique corners
These two pieces are a fast and easy print and make glueing unnecessary or easier, however you prefer. My print could not be glued at all due to warping which motivated the creation of these clamps. No specific requirements regarding…
Various round covers for holes and breakouts
the plastic pieces in my kit had a slight bow to them and I wanted to make sure they were glued in properly. This is what I came up with. You'll need 8 m3X5X5 heat set inserts as well as 8 m3X10 screws. You should be able to print…
Glueing jig for a gear which was broken. Category: Replacement Parts
A simple hook. Flat back; can be mounted with glue or mounting tape. 50mm tall, 20mm wide, 32mm overall width, about 20mm internal width. Dimensions can be adjusted easily by scaling in the slicer. Made for headphones, but good for…
