Counting matching models…
This is my take on the classic corn sheller. Print with the wide, thin edge against the build plate using a thin brim as support. I suggest a more rugged material such as PLA+ or ABS. As always make sure your machine is dialed in and your…
⚙ RECOMMENDED 3D PRINT SETTINGS Material: PLA or PLA+ recommended Layer Height: 0.16 mm for finer detail; 0.20 mm for faster prints Infill: 10–15% recommended for most models Wall Loops: 2–3 Supports: Enable where necessary based on model…
Memoir 44 : ultra basic stand to adapt Heller miniatures which base is too narrow to Memoir 44 standard base Memoir 44 base is 16 x 14.5 mm, Heller's miniature have a 12.3 x 7.4 base, which is impossible to play with without falling. I…
The motor housing for my Heller STV-407 ventilator broke, so I modelled and printed a new one.
To put this to use, you'll need to print 3 parts and drill a 1/8" hole thru the lever shaft. Center the drilled hole 1 3/16" from the upper pivot point on the shaft. You'll also need (2) 3/32" cotter pins for pivots.
We design the handle to replace the original beacuse it was deteriorate This piece is in TPU, we used TPU 85A to get a low shore hardness and it fit in the tool with facility because it can be folded. Also you find the STEP if you need…
We design the handle to replace the original beacuse it was deteriorate This piece is in TPU, we used TPU 85A to get a low shore hardness and it fit in the tool with facility because it can be folded. Also you find the STEP if you need…
Support pour 6 pots de peintures Enamel de marque Heller ou tout autres pots de peinture de 31 mm de diamètre. Imprimer avec des petits supports pour le lettrage mais ce n'est pas obligatoire.
The Streets of San Francisco - Insp. Steve Heller (Michael Douglas) and Lt. Mike Stone (Karl Malden) - 1972-1976 3D printable model.
