Counting matching models…
Set of nozzle for the handheld fan Jisulife Pro1S. They provide them for the Ultra1 but not the others models so I made them. Flat beak like an air dryer Cone nozzle to concentrate the airflow Inverted cone to widen the area of effect The…
I designed this stand for the jisulife life7 fan, it allows the fan to be used at more angles for example when sitting at a desk. Also ideal for storage as it takes up less horizontal space. Print without supports at 0.2mm. Printed in…
simple fan stand for the Jisulife Ultra 2, print in PETG 0.2mm for best results
I needed to focus the airflow off a JisuLife Portable Fan 9 into a narrow area & increase flow, so I printed this nozzle in TPU 95 A. Slides on the fan and stays on during well. Printed on Prisa Mk4 using 0.20mm Structural and Generic…
It’s quite stable but it might become less so if you turn the fan on full power. It won’t fall over at full speed but avoid bumping it too hard. I designed it with a 15-degree tilt which is about the maximum it can tilt before becoming…
I liked the general design of Rhazgular's Flashtool from Thingiverse but did not intend to integrate a complete FTDI assembly into it and use a pin header instead. So I decided the original design was a bit too much for me and cut down…
This is a minimalistic adapter thing to flash those sp111 with little effort. I mean yes I had to soldered a bit at the pogo pins but this was much simpler than trying to get the PCB out or solder in the housing. An advantage here is that…
Simple Straight forward just print wi 40% infill.I used PLA. The off stands are fixed with tapping screws 2,2x4,5 DIN 7981 against the bottom grid. The SSD directly to the plate with HDD screws.
Designed this holder for the Jisulife Life 9 Fan to mount onto a flexible tripod, allowing it to be attached to a stroller. A tight fit so that it it doesnt fall out during movement.
Print without supports in 0.2mm. Attach to wall using 3m command strips or similar. Fan should fit snuggly into the holder
This is a very quick plan and solution to prevent the child's ventilator from falling over on the bedding. I also made a lighter version so that you don't need as much filament.
