Counting matching models…
This is replacement parts of headband (plastic portion only) for AKG K7XX variants, and that transparent plastic attached to inner slider. The models themselves are flat, you need to print them with PETG or other flexible/ductile…
This is a fix for the elastic bands in AKG K701, K702, K712, and AKG K7XX headphones. It's been tested on the K712 Pro and should work for similar models. You'll need an elastic hair tie and glue for installation. If you want to you can…
This is a clip in bracket to replace the worn out elastic for an AKG K7xx (701/702/712/others) series headphone. Requires no disassembly, modification, cutting, gluing, etc. It is designed for a hair elastic (ponytail elastic) of about…
Was getting frustrated with the modmic losing adhesion from the k7xx headphones as there was no perfect spot for it. Designed this to allow for a solid surface for the modmic to attach to. I printed mine with the pad side down. Category:…
Print everything twice for a full set. You can add L and R indicators on the preferred covers with the “Add negative volume” option in your slicer if you wish. AKG shipped these with L and R on what is similar to the TopOutside model.…
A newer version of the mic arm addon for my AKG K7XX with my Sony ECMCS3 mic from my previous model: https://www.thingiverse.com/thing:2481074 This one is heavier but the mic is removable with the cables so I can take them off anytime and…
I design this for my modular monitor attachment but I figure some people will find it useful. Pic is slightly different since design has change slightly to match with the table/wall mounting. The headphone holder can rotate to accommodate…
i remixed the original to have a wall around the magnet thing. also i changed the hole to fit m3 4mm FCHS screws which screw directly into the plastic. if you want to avoid that it will probably also work with hotglue
i remixed the original to have a wall around the magnet thing. also i changed the hole to fit m3 4mm FCHS screws which screw directly into the plastic. if you want to avoid that it will probably also work with hotglue
Updated to a newer version here: https://www.thingiverse.com/thing:2894679 This model (V1) is easier/quicker to print and is light weight but the joint tend to loosen overtime. A mic arm addon for K7XX (should also work with some other…
