Counting matching models…
Generic replacement foot for most HP/Agilent/Keysight instruments that use the normal clip-on feet, with or without the flip-down wire. There are separate front and rear feet (some instruments were shipped with distinct ones; others seem…
These are a set of replacement knobs commonly used across much of the equipment produced by HP/Agilent/Keysight. Since replacement knobs direct from Keysight or Ebay are way too expensive I decided to design a set of knobs in the common…
I needed to record some results from my Keysight U1701B Capacitance meter, but didn't have the correct IR download lead for it. On a hunch, I held my Fluke IR189 up to the IR port and watched a serial terminal on the PC. Results appeared,…
Keysight U123xA Mod / Repair range selector
Replacement for HP,Agilent, Keysight back panel of half rack 2U units. I'll tune the 3U at some point. Most printers can't handle the full width rack but willing to let someone test it and then upload it once fitted properly.
This is a replacement foot for the DSO-X2000 and 3000 series (same chassis). It may fit other models too, but I've only got 2000 and 3000s to try on.
A simple model, made to replace the kickstand on my U1242C, which mysteriously disappeared one day. While I made it specifically for this model, it should fit models with similar proportions. Recommendations: Print in stronger materials…
The rod of y powerswitch of my old Agilent 34401A multimeter broke, so I decided to rebuil a replacement. For easy and nice print I spltted it into three parts: - The pushbottun - rod part 1 - rod part 2 Because my original rod completely…
This includes (effectively) 5 different models. This includes: One normal discharge profile, including voltage and internal resistance One zero-degrees Celsius discharge profile, including voltage and internal resistance A rudimentary…
The ears are a snap fit to the belt attachments. Print the right ear and mirror it for the left side.
This is a model of the plastic piece that covers the front end of the carry handle on the HP/Agilent/Keysight 6645A system power supply. It will fit all models from the 6640A and 6540A series, and potentially other system power supplies…
I needed extra storage for scope probes and hooks for my DSO-X 3000A oscilloscope. This mounts onto the rear trig-in and trig-out BNC connectors. You will need a spare BNC connector to lock it in place. Note that the mounting tab was too…
There are several diy board designs for adding an ethernet connection to DSO2000/3000 series oscilloscopes. One such board is available from OSHPark. This design attaches to the OSHPark board to guide and hold it in position. There is an…
Keysight 34465a digit multimeter hang
