15 models
Воронка для маслозаливной горловины автомобиля Тойота, двигателя 4GR-fse, резьба М37х3мм Funnel for oil filler neck of Toyota car, 4GR-fse engine, thread M37x3mm
For my first robot project I want to use the URM37 ultrasonic distance sensor from dfrobot. So the first thing to do was to design a good housing for the sensor and make it attachable to a servo. Category: Robotics
My setup: Schneider Kreuznach Componon 28mm f2.8 reverse mounted on the hood thread (M37x0.75) Tube lens: Carl Zeiss Jena 3.5/135mm (M49x0.75) It covers a full frame with noticeable vignetting at full aperture on the tube lens. Printed…
I bought from aliexpress but with no pci barcket so i made it myself. Enjoy !
laher height 0.2mm
This adapter reduces a 37mm hole threaded for M37-1.5 down to a 32mm hole threaded for M32-1.5. ABB robot power control cables use a non-standard M37 threaded connector on one end and an industry standard M32 threaded connector on the…
m42 to m37 Diameter: 42mm Pitch: 1mm Diameter: 37mm Pitch: 0.75mm
This is a model of the drive shaft gear for the Industrix M37 Plus machine. The first section is for receiving film. We use this machine for developing X-ray images, and we've encountered a problem where the gear constantly breaks down.…
I printed without supports with using PLA.
I used 4x M3 thread inserts with 4mm diameter and 4mm length. I put them into place with a soldering iron heated to ~250°C. As screws I used 4x M3x8mm countersunk head. The housing was printed with a 0.6mm nozzle at 0.25mm layer height…
Print Settings Rafts: No Supports: Yes Infill: 100% Filament: Any PETG
Cut height adjuster for Makita ELM3720 lawnmower with four height settings. Second model has less play in the movement slot.
replacement rubber grommet, Douglas connector for Jeep M38, M38A1, Dodge M37 and other military vehicles, printed from TPU 92A. Náhradní průchodka konektoru Douglas pro Jeep M38, M38A1, Dodge M37 a jiné vojenské vozidla. Vytištěno z TPU…
Headset top cap transition spacer that fits on top of the seal ring and to the Kreuza Apex GR cockpit - 10mm height. While not ideal, i am using PETG printed headset top spacers for a while without problems. Make sure to set many wall…
This is a model of the drive shaft gear for the Industrix M37 Plus machine. The first section is for receiving film. We use this machine for developing X-ray images, and we've encountered a problem where the gear constantly breaks down.…
